SYSTEM SETUP : Basic
Adjust basic system settings.
Language
Choose the language in which menus and messages are displayed.
Menu Settings
Adjust menu display settings.
Press ENTER to display options and then select the desired item.
Menu display time
Choose how the menus are displayed.
Select Always to display the menus indefinitely.
Options | ||||
---|---|---|---|---|
5 sec | 10 sec | 20 sec | 30 sec | Always |
Menu position
Choose where the menus are displayed.
Options | ||||
---|---|---|---|---|
Center | Bottom-Left | Bottom-Right | Top-Left | Top-Right |
Reminder Message
Select On to display alerts.
Background Color
Choose the menu background color.
Options | |||
---|---|---|---|
FUJIFILM (Blue) | FUJIFILM (Black) | Black | Blue |
Operation Settings
Adjust timer and other settings.
Press ENTER to display options and then select the desired item.
Direct Power On
If On is selected, the projector will turn on automatically when connected to an input device.
Auto Power Off
Choose the delay before the projector turns off automatically.
Options | ||||||
---|---|---|---|---|---|---|
Disable | 3 min | 10 min | 15 min | 20 min | 25 min | 30 min |
Blank Timer
Choose the delay before the display turns off automatically.
Options | ||||||
---|---|---|---|---|---|---|
Disable | 5 min | 10 min | 15 min | 20 min | 25 min | 30 min |
Sleep Timer
Choose the delay before the projector enters sleep mode.
Options | |||||||
---|---|---|---|---|---|---|---|
Disable | 30 min | 1 hr | 2 hr | 3 hr | 4 hr | 8 hr | 12 hr |
Remote Receiver
Choose the remote receivers used.
Options | ||
---|---|---|
Front+Rear | Front | Rear |
Panel Key Lock
Selecting On displays a confirmation dialog.
Select Yes to lock the buttons on the projector control panel.
Projector ID Setting
Choose the projector ID.
The ID can be set to any number between 1 through 99. The factory default is OFF. When OFF is selected, the projector can be controlled by any remote whatever its ID.
bTIP
The remote control must be matched to the selected ID. To do so, hold the IDSET button on the remote control and enter the projector ID.
For example, if the projector ID were set to “2”, you would hold the IDSET button on the remote control while pressing first 0 and then 2.
Use the keys on the projector control panel to choose the projector ID.