Menu List
The projector menus are organized as shown below.
DISPLAY
Item | Options (defaults in bold) |
---|---|
Lens Setting | Lens shift: — |
Lens shift settings: Shift area (Limited / Full) / Auto lens shift (On / Off) / Home Position | |
FOCUS 1: — | |
FOCUS 2: — | |
Zoom: — | |
Test Pattern | Off / 1 / 2 / 3 / 4 / 5 / 6 / 7 / 8 / 9 / 11 / 12 / 13 |
Projector Position | Front Table / Rear Table / Rear Ceiling / Front Ceiling |
Aspect Ratio | Auto / Real / 4:3 / 16:10 / 16:9 |
Keystone | Axis - Vertical (V): -60 – 0 – 60 |
Axis - Horizontal (H): -60 – 0 – 60 | |
Corner Fit | V (Vertical): 0 – 60 |
H (Horizontal): 0 – 60 | |
Blanking | Upper (0 – 300), Lower (0 – 300), Left (0 – 500), Right (0 – 500) |
Digital Zoom | 1.0 – 2.0 |
Raster Position | With a 16 : 9 input signal: Upper (0 – 60), Lower (0 – 60) |
Lens Rotation setting | — |
PICTURE
Item | Options (defaults in bold) |
---|---|
Picture Mode | Bright / Standard / sRGB / DICOM SIM |
Brightness | 0 – 50 – 100 |
Contrast | -50 – 0 – 50 |
Tint | -45 – 0 – 45 |
Color | -50 – 0 – 50 |
Gamma | 1.6 – 2.2 – 3.3 |
Sharpness | 0 – 15 – 31 |
Color Temperature | 3200K – 7100K – 9300K |
Color Temperature Fine Tuning | R / G / B Gain: 0 – 100 – 200 |
R / G / B Offset: -50 – 0 – 50 | |
7colors Tuning |
R, G, B, C, M, or Y Selected for Color
|
W Selected for Color
|
SOURCE
Item | Options (defaults in bold) |
---|---|
Quick Auto Search | On / Off |
INPUT | HDMI1 / HDMI2 / DisplayPort / HDBaseT / SDI |
HDMI Range | Auto / Full / Limited |
Color Space Conversion | Auto / RGB / YUV |
HDMI Equalizer | Auto / lower / low / middle / high / higher |
SYSTEM SETUP : Basic
Item | Options (defaults in bold) |
---|---|
Language | 18 languages |
Menu Settings | Menu display time: Always / 30 sec / 20 sec / 10 sec / 5 sec |
Menu position: Center / Bottom-Left / Bottom-Right / Top-Left / Top-Right | |
Reminder Message: On / Off | |
Background Color | FUJIFILM(Blue) / FUJIFILM(White) / FUJIFILM(Black) / Black / Blue |
Remote Receiver | All / Front+Side / Rear+Side / Side |
Panel Key Lock | On / Off |
Projector ID Setting | 01 – 99 / Off |
Security Settings | Power on Lock: On / Off |
Audio Settings | Mute: On / Off |
Volume: 0 – 5 – 10 | |
source (FP-Z8000 only): On / Off | |
High Altitude Mode | On / Off |
Reset Settings | — |
SYSTEM SETUP : Advanced
Item | Options (defaults in bold) |
---|---|
Light Source Mode | Normal / Eco(60%) |
Light Output Setting | 20 – 100 |
Light Source Information | — |
Shutter Setting | Fade-in: Off / 0.6s / 1.0s / 2.0s / 3.0s / 4.0s / 5.0s / 7.0s / 10.0s |
Fade-out: Off / 0.6s / 1.0s / 2.0s / 3.0s / 4.0s / 5.0s / 7.0s / 10.0s | |
Dynamic Black: On / Off | |
Dynamic Contrast Ratio: On / Off | |
Operation Settings | Direct Power On: On / Off |
Auto Power Off: Disable / 3 min / 10 min / 15 min / 20 min / 25 min / 30 min | |
Fade-Out timer: Disable / 5 min / 10 min / 15 min / 20 min / 25 min / 30 min | |
Sleep Timer : Disable / 30 min / 1 hr / 2 hr / 3 hr / 4 hr / 8 hr / 12 hr | |
Date and Time Setting | Date / Time |
Schedule Setting | On / Off |
Control Channel | LAN・RS-232C / HDBaseT |
Standby Settings | Enable Network Standby Mode: On / Off |
Switch to Normal Standby Mode: Off / 20 min / 1 hr / 3 hr / 6 hr | |
LAN Settings | AMX Device Discovery: On / Off |
DHCP: On / Off |